Amcor 83mm 5-11 Lining System
Search both operator books — lining machine and vision cell — then ask a floor question with citations. Changeover, belt swap, recipes, parts.
Safety first
PPE, LOTO, and unsensored vision doors.
OpenStart the liner
Power-up, ten-point checklist, hold CYCLE START three seconds.
OpenLiner changeover
Thirty steps from energy isolation through CYCLE START.
OpenVision belts
Infeed and both inspection conveyors, white or black.
OpenHMI map
Liner screens and the vision camera / recipe desk.
OpenFault codes
167 named A/W codes from setup 9002153, plus a floor log.
OpenParts book
Both BOMs plus factory-recommended spares.
OpenService ratings
Power and air
- Input voltage
- 480 VAC
- Service
- 30 A
- Frequency
- 60 Hz
- Phase
- 3
- Full-load amps
- 9.55 A
- SCCR
- 100 kA
- Supply
- 80 PSI — 5 SCFM
Keep the machine powered unless you are locking out. Blue System On brings control power back; the red panel knob is the disconnect.
Stack light
Tower codes
Solid red
Stopped, no alarm present.
Flashing red
Stopped with an alarm (red banner on the HMI).
Solid amber
Manual mode.
Flashing amber
Warning present (yellow banner on the HMI).
Solid green
Producing.
Flashing green
Starting in Auto mode.
Solid blue
Low on material.
Line layout
Lining stations
- AVision system
- BStack light indicator
- CInfeed conveyor
- DSorter
- EFeeder
- FHMI screen (×2)
- GCap spinner bowl
- HNip roller / unwinder
- IManual pedal
9002426-06
Vision cell
Long-side guard doors latch but are not sensed on the HMI. If the cell loses air, it rejects every cap.
- AReject chutes
- BGuard doors (unsensored)
- CHMI
- DInfeed
- EFRL
- FElectrical panel
- GEthernet port / outlet
- HGuard doors (unsensored)
- IE-stop
- JOutfeed
- KBlower