Care chart

Clean the press station and apply synthetic lubricant to the cam linkages.

Clean the press station and apply synthetic lubricant to the tamper shaft, cam, and spring assemblies.

Inspect for rips, tears, or stretching. Replace as required. Clean only with mild soap and water.

Thoroughly clean the machine table. Remove all dirt and debris.

Ensure that all connections are tight and functioning.

Clean every two weeks. Gently blow off with clean, dry compressed air.

Apply grease to the manifold under the table and verify grease reaches plates above and below the scotch yoke.

Check and replace as needed.

Empty and thoroughly clean.

Apply 2–3 shots of grease to all grease zerks on bearing housings. Recommended: synthetic general-purpose grease, translucent white, food-grade, 45°F max temp, NLGI G-2.

Check belt condition. Visually inspect for tears or discoloration and replace as needed. White and black belts are supplied for contrast with the cap color.

Wipe all sensors with a clean, lint-free cloth.

If focus is poor or the image is dirty, inspect the lens for dirt or debris and clean it gently with a lint-free cloth.

All Vision System bearings are sealed and lubricated for life. Do not lubricate.

If the machine loses air, it defaults to rejecting all caps. Restore air at the FRL under the infeed, then clear alarms.